Using loudspeaker riser foam to dampen noise from printer - Would it work?
 
Notifications
Clear all

Using loudspeaker riser foam to dampen noise from printer - Would it work?  

  RSS
maverickdelta
(@maverickdelta)
New Member
Using loudspeaker riser foam to dampen noise from printer - Would it work?

Hello,

Would using a foam riser used for loudspeaker (like the Pyle Sound Dampening Speaker Riser Foam sold on Amazon) be effective to reduce noise from a printer?  It has a foam-covered wooden top to keep the surface flat.

Posted : 03/03/2021 6:50 am
cwbullet
(@cwbullet)
Member
RE: Using loudspeaker riser foam to dampen noise from printer - Would it work?

I think this would work. I am sure it would dampen the sound a little, but silicone feet should work just as much. I would try it and post the results.

--------------------
Chuck H
3D Printer Review Blog

Posted : 03/03/2021 10:46 am
John Doe
(@john-doe-3)
Estimable Member
RE: Using loudspeaker riser foam to dampen noise from printer - Would it work?

All these "putting" foam into or near enclosure is a good idea due to sound. However be careful, that foam is usually very flammable, so it can very easy catch fire from very hot parts of printer or when there something overheat.

Posted : 03/03/2021 11:20 am
cwbullet
(@cwbullet)
Member
RE: Using loudspeaker riser foam to dampen noise from printer - Would it work?

@john-doe-5

They make non-flammable versions.

--------------------
Chuck H
3D Printer Review Blog

Posted : 03/03/2021 11:22 am
hli
 hli
(@hli)
Trusted Member
RE: Using loudspeaker riser foam to dampen noise from printer - Would it work?

Put the printer on a stone paver or something heavy, and then the noise dampeners underneath. You want to decouple the printer movements as much as possible from any resonating surface (that's what the dampeners are for), but at the same time the printer should be as steady as possible (because otherwise acceleration changes, such as printing sharp corners, will move the printer too much which worsens print quality). Also, the heavy mass helps in dampening noise.

Posted : 03/03/2021 12:06 pm
MAX1
 MAX1
(@max1)
Eminent Member
RE: Using loudspeaker riser foam to dampen noise from printer - Would it work?

Get everything at the big box home store 

Here is what I did

Also, if anyone is interested, how to adapter food dehydrator to dry filament.

 

Posted : 19/03/2021 5:25 am
Share: