Notifications
Clear all
Prusa Mini+ switch cable
Hi,
Trying to move the on/off switch for the Mini+ to the front. What cables should I be using for this and where can I get these cables? Also, for the spade terminals, what size should I be using?
Thanks,
Posted : 15/07/2021 7:46 am
cables
Here is a thread on the power cable:
I would replace the whole cable to get a better connection and avoid incomplete soldering.
For USB, almost any USB extension cable will work. The link is on Amazon, but you can find them elsewhere.
--------------------
Chuck H
3D Printer Review Blog
Posted : 15/07/2021 10:32 am
skweng liked
x
I used 16 AWG (American Wire Gauge) twin electrical wire and four 16-14 gauge (blue) female quick connectors. Strip a few mm off the ends of the wire and crimp on the quick connectors. See https://www.prusaprinters.org/prints/67778
Posted : 15/07/2021 12:29 pm
skweng liked