Filament change with OctoPrint?  

  RSS
kermur
(@kermur)
New Member

I have been using OctoPrint with my mini for a few weeks with no issues. I did not have to adjust any settings that I would configure for any other printer.

I did, however, encounter a problem today, I was printing something that had a filament change in the .gcode. The Mini pasued at the correct point, but it would not allow me to load the next color (Octoprint lock-out screen).

Has anyone encountered this same behavior? If so, is there a known work-around?

I guess I'm back to printing from USB when I have filament changes...

Posted : 23/04/2020 6:18 pm
Gordon W
(@gordon-w)
Reputable Member

It is a known issue ( https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/362  ) but unfortunately I'm not aware of any workaround for the issue.

 

Posted : 23/04/2020 6:46 pm
kermur liked
Share:

Please Login or Register