Notifications
Clear all

0.4 nozzle clogging constantly  

  RSS
Macho burrito
(@macho-burrito)
New Member
0.4 nozzle clogging constantly

Hi All,

  Seeking advice as to what could be going on with my mini when trying to print with the 0.4 nozzle. The default set up I was always getting clogging issues. Then as an experiment I swapped the nozzle for a larger 0.8 nozzle and I have no more clogging issues when printing.

I would like to be able to use a smaller nozzle in the future, what should I do or check when stepping down to a smaller nozzle?

Posted : 17/10/2021 1:47 pm
fuchsr
(@fuchsr)
Famed Member
RE: 0.4 nozzle clogging constantly

Not much to go with here. What filament are you trying to print? What temperature? Will it load properly and come out fine, or will it clog right away? Do you hear any clicking from the extruder?

Posted : 18/10/2021 12:56 am
Share: