Notifications
Clear all

What is this?  

  RSS
gfk
 gfk
(@gfk)
New Member
What is this?

Hi,
New here and new to Prusa Slicer. I have a qustion about a print I'm printing witch have a small "defekt" and I can't seem to figure out why?? 
The vertical lines see here are in the print as well. How do I get rid of them?
https://imgur.com/Q0LsKAZ

https://imgur.com/lP3EAi0

Thanks
Gert

 

Posted : 02/11/2019 7:11 pm
Lichtjaeger
(@lichtjaeger)
Noble Member
RE: What is this?

I assume you are talking about the seams (start and endpoints of a layer). You can't get rid of them. You can only change there placement.

Posted : 03/11/2019 10:48 am
gfk
 gfk
(@gfk)
New Member
Topic starter answered:
RE: What is this?

Found the answer here:
https://forum.prusaprinters.org/forum/prusaslicer/prusa-slicer-2-0-how-would-i-go-about-to-get-rid-of-that-vertical-seam/

Posted : 03/11/2019 1:24 pm
Share: