Notifications
Clear all
Vase mode not working
Help with vase mode
So after months of successful prints I’m trying to use vase mode and failing miserably. Same results with prusa slicer and simplify 3D. I load the file check off vase mode then slice and export. What happens is the first bottom layers are fine but then instead of it extracting filament in a circular pattern it drops a little blob, goes back to the center of the model, goes back, drops another little blob, back to center..... am I’m missing something in the settings?
I tried 2 different models made for vase mode with the same results it drops a blob goes to center goes back drops a little blob next to the previous one. Repeats over and over.
This topic was modified 4 years ago by Jay
Posted : 09/12/2019 2:33 am