Thin walls in one go (aside vase-mode)
 

Thin walls in one go (aside vase-mode)  

  RSS
Silvester
(@silvester)
New Member

Hello,

i am struggling to print thin walls - somewhere around 0.45 mm - in one go (like in vase-mode).

I find that the nozzle travels each way twice at the same z-value (or not at all if the wall is slightly thinner than the perimeter-setting).

Is there a way to achieve this? I can not use vase mode though for it is not a closed form.

I am using PrusaSlicer Version 2.3.0 linux x64, Prusa i3 MK3 and a 0.4mm standard nozzle.

Thank you so much!

 

Posted : 19/04/2021 6:38 pm
Diem
 Diem
(@diem)
Honorable Member

Have you enabled 'Detect thin walls' in Print Settings?  You might need to be in Expert mode.

Cheerio,

Posted : 20/04/2021 12:25 pm
Silvester
(@silvester)
New Member

'Detect thin walls' works so far. Thank you very much!

Posted : 29/04/2021 11:14 am
Share:

Please Login or Register