Prusa Slicer wont check bounds
Clear all

Prusa Slicer wont check bounds  

New Member
Prusa Slicer wont check bounds

when I start printing on my klic n print using the Prusa slicer, it just starts printing, it doesn't check its bounds or its orientation (I think, I don't know the terminology) and it doesn't raise the bed to where the extruders are so it just starts printing in midair. Any help would be greatly appreciated.

This topic was modified 1 year ago 2 times by pugkeegan
Posted : 29/06/2020 3:28 pm