PS 2.3.0 takes about a minute to launch
 
Notifications
Clear all

PS 2.3.0 takes about a minute to launch  

  RSS
prusanewuser
(@prusanewuser)
Prominent Member
PS 2.3.0 takes about a minute to launch

Hi, I have been using PS 2.3.0 Windows 10 since it became available. Usually it launched very quickly in a few seconds but for the past two days, it takes about a minute to launch. I keep getting "Preparing setting tab" during launch. What is that? How can I speed it up like before?

Posted : 14/05/2021 4:42 am
jweaver
(@jweaver)
Honorable Member
RE: PS 2.3.0 takes about a minute to launch

https://forum.prusa3d.com/forum/prusaslicer/slicer-wont-start-hangs-on-preparing-settings-tabs/

Posted : 14/05/2021 10:24 pm
cwbullet
(@cwbullet)
Member
RE: PS 2.3.0 takes about a minute to launch

I have noticed the delay in launching.  You get used to it.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 15/05/2021 2:54 pm
--
 --
(@)
Illustrious Member
RE: PS 2.3.0 takes about a minute to launch

Turn off the CHECK FOR UPDATES feature.

Posted : 15/05/2021 9:48 pm
Share: