Notifications
Clear all
Prusa Slicer Support Request: Horizontal Expansion
Is there a setting for for Horizontal Expansion concerning supports.
I am looking for something like this in CURA.
https://support.ultimaker.com/hc/en-us/articles/360012612779-Support-settings
My problem is I am supporting a raised platform and the edges are peeling up because the support stops at the same edge.
Posted : 12/11/2021 7:00 pm
RE: Prusa Slicer Support Request: Horizontal Expansion
You can angle the supports, which makes them stick out a bit.
See Print Settings - Support material - Options for support material and raft - Pattern angle
Having problems with bed adhesion every morning...
Posted : 13/11/2021 6:34 am