Problems with PrusaSlicer 2.3.0 Alpha 0
 
Notifications
Clear all

Problems with PrusaSlicer 2.3.0 Alpha 0  

  RSS
Xayoz
(@xayoz)
Eminent Member
Problems with PrusaSlicer 2.3.0 Alpha 0

So I downloaded the git from https://github.com/prusa3d/PrusaSlicer

 

Followed the Noob Guide at the end of https://github.com/prusa3d/PrusaSlicer/blob/master/doc/How%20to%20build%20-%20Windows.md

 

Then I get the attached errors and can't go any further.  What am I doing wrong?

 

Posted : 08/07/2020 10:40 pm
Neophyl
(@neophyl)
Famed Member
RE: Problems with PrusaSlicer 2.3.0 Alpha 0

You are better off asking on the github.  Far more people likely to know the answer over there.  I do know that the documents arent kept that up to date and I recall there actually already being several issues already asking about compiling errors.

Posted : 09/07/2020 6:18 am
Xayoz
(@xayoz)
Eminent Member
Topic starter answered:
RE: Problems with PrusaSlicer 2.3.0 Alpha 0

Here is the fix that worked:

Close Visual Studio
Navigate to <your project folder>\build\.vs\PrusaSlicer\v16"
Delete the .suo file
Open Visual Studio and all was well again.

Posted : 09/07/2020 4:52 pm
Xayoz
(@xayoz)
Eminent Member
Topic starter answered:
RE: Problems with PrusaSlicer 2.3.0 Alpha 0

Next issue is after compile, what am I doing wron trying to run it?

I follow the "Debug->Start Debugging or Debug->Start Without debugging PrusaSlicer should start. You're up and running!" instruction and get this...

 

Posted : 11/07/2020 5:27 pm
andrew.m70
(@andrew-m70)
New Member
RE: Problems with PrusaSlicer 2.3.0 Alpha 0

Did you ever find a solution to this?  I also receive the same error after several attempts. 

Posted : 08/08/2020 9:29 pm
Xayoz
(@xayoz)
Eminent Member
Topic starter answered:
RE: Problems with PrusaSlicer 2.3.0 Alpha 0

@andrew-m70

https://3dprint.boards.net/thread/13/prusaslicer-2-alpha-compile-error?page=1&scrollTo=28

Posted : 12/08/2020 5:22 pm
Colin
(@colin-4)
Estimable Member
RE: Problems with PrusaSlicer 2.3.0 Alpha 0

Any solutions?  I followed the above link but I didn't see anything that helped.

 

Posted : 04/09/2020 3:11 pm
Xayoz
(@xayoz)
Eminent Member
Topic starter answered:
RE: Problems with PrusaSlicer 2.3.0 Alpha 0

the final post, "build solution"

Posted : 04/09/2020 4:14 pm
Share: