Object outside print volume...when its not
 
Notifications
Clear all

Object outside print volume...when its not  

  RSS
mchahn
(@mchahn)
Eminent Member
Object outside print volume...when its not

I know there is another post with this same exact subject line, but this is different.  I have a bucket created with fusion360 that is 190 mm in diameter.  Its exterior is an exact cylinder.  When I export the bucket to pslicer with prusa i3  mks3+ printer set I get the error "Object outside print volume".  You can see from the attached screenshot that it fits. 

What can I do about this?

Best Answer by mchahn:

It was too tall.   (Is there a way to delete posts?)

Posted : 13/10/2021 10:40 pm
mchahn
(@mchahn)
Eminent Member
Topic starter answered:
duh, found my problem

It was too tall.   (Is there a way to delete posts?)

Posted : 13/10/2021 10:48 pm
fuchsr
(@fuchsr)
Noble Member

Too tall?

Posted : 13/10/2021 10:49 pm
Share: