Notifications
Clear all

Manual Location?  

  RSS
Ben V
(@ben-v)
Active Member
Manual Location?

I have been looking for the location of the online manual for Prusa Slicer. I can find Slic3r, but not our baby with all its bells and whistles. Specifically, I was looking for something in help where I could look up a button I didn't understand: In sliced view, where you set layer height view (for setting filament/color change), at the bottom is a lock that says, when you hover over it: "One layer mode" which I don't understand. I can't seen to find any more detail about it anywhere else. 

So, can you help me by sharing/pinning a link to the manual (where, ostensibly, the answer to this question can be found) or provide a further explanation of "One layer mode" in that lock icon? 

Thanks,

Ben

-ben

Posted : 02/11/2019 7:14 pm
Lichtjaeger
(@lichtjaeger)
Noble Member
RE: Manual Location?

The "one layer mode" is exactly what it sounds. It shows one layer and one layer only. The two handles of the slider become one.

At the moment there is no handbook. Most exotic features are shown on Prusa's YouTube or Chris Warkockies.

Posted : 03/11/2019 10:24 am
Share: