Notifications
Clear all

Machine limit control  

  RSS
qwewer
(@qwewer)
Active Member
Machine limit control

Is there a way to not include machine control commands (M201, M203, M204, M205) in the gcode files that PrusaSlicer makes? Without manually deleting it form the gcode file, of course.

Posted : 28/06/2020 6:00 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Machine limit control
Posted by: @cool-kornel

Is there a way to not include machine control commands (M201, M203, M204, M205) in the gcode files that PrusaSlicer makes? Without manually deleting it form the gcode file, of course.

Hello and welcome in Prusaforum!

You could make special changes to the gcode with a post processor script:

http://projects.ttlexceeded.com/3dprinting_prusaslicer_post-processing.html

However, programming knowledge in perl, python or similar is required.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 28/06/2020 11:18 pm
qwewer liked
Neophyl
(@neophyl)
Illustrious Member
RE: Machine limit control

Instead of selecting Marlin as your gcode type choose rep rap instead. That will then not include the codes but otherwise the content is the same. 

Posted : 29/06/2020 12:06 am
qwewer liked
qwewer
(@qwewer)
Active Member
Topic starter answered:
RE: Machine limit control

@neophyl

Just what I needed, it only removes those lines/commands. Thank you.

Posted : 29/06/2020 8:26 am
Share: