Infill 15% slices fine, change infill to 60% Prusaslicer dies a slow death....
 
Notifications
Clear all

Infill 15% slices fine, change infill to 60% Prusaslicer dies a slow death....  

  RSS
Hildow
(@hildow)
New Member
Infill 15% slices fine, change infill to 60% Prusaslicer dies a slow death....

Having Problems with PrusaSlicer.  (File attached), on two different systems I can slice successfully at 15% infill, but if I increase infill from 15% to 60%, PrusaSlicer bogs down, then goes permanently non-responsive upon attempting to slice.

Using 2.3.2 -- Any Suggestions?

Tray of SmallHandle3

This topic was modified 3 years ago 2 times by Hildow
Posted : 01/09/2021 1:20 pm
Share: