Gap when switching from single perimeter to double perimeter
 
Notifications
Clear all

Gap when switching from single perimeter to double perimeter  

  RSS
namron
(@namron)
Active Member
Gap when switching from single perimeter to double perimeter

Hi, 

I want to print this thing.

Halfway through the print I noticed a gap on the backside of the fan duct. The model itself is fine, it seems to be an issue with extrusion width.

I have a 0.4mm nozzle on my Artillery Genius and 'Default extrusion width' is set to '0', so according to the tooltip the extrusion width is 0.4mm  x 1.125 = 0.45mm. It seems the gap results from the transition from a single perimeter to a double perimeter:

 

When manually lowering the extrusion width to 4.1mm the gap is gone:

 

 

I would at least have expected PrusaSlicer to warn me when creating a gap in the outer perimeter. Better even suggesting the decreased extrusion width or solving the issue somehow else on it's own.

 

Is there any setting that would help to avoid this?

Opublikowany : 27/11/2020 12:30 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Gap when switching from single perimeter to double perimeter

XY Size Compensation. in expert mode, under Print Settings>advanced sub menu

try say 0.05mm, or maybe 0.1mm

Or try a 0.25mm nozzle with appropriate settings.

 

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Opublikowany : 27/11/2020 7:48 pm
Neophyl
(@neophyl)
Illustrious Member
RE: Gap when switching from single perimeter to double perimeter

You can also try turning 'detect thin walls' on/off as that usually makes a difference to effects like that.  

Also when it actually prints its not likely to have that gap as the walls will merge,  often those are a shortcoming of the preview renderer.

Opublikowany : 27/11/2020 9:01 pm
namron
(@namron)
Active Member
Topic starter answered:
RE: Gap when switching from single perimeter to double perimeter

@neophyl

Turning off 'Detect thin walls' fixed it with 0.45mm extrusion width. Thanks!

Opublikowany : 28/11/2020 9:30 am
towlerg
(@towlerg)
Noble Member
RE: Gap when switching from single perimeter to double perimeter

@namron Are you happy with the Genius? Any issues with the ribbon cable?

Opublikowany : 28/11/2020 10:51 am
namron
(@namron)
Active Member
Topic starter answered:
RE: Gap when switching from single perimeter to double perimeter

@towlerg

I just have the printer for  2 weeks now, so no long-term experience. But for now I am really happy with it. Printing results are exceeding my expectations and absolutely no problems with the ribbon cables so far.

Opublikowany : 28/11/2020 12:13 pm
Share: