Filling the area in a strange way between circular perimiters
 
Notifications
Clear all

Filling the area in a strange way between circular perimiters  

  RSS
dma_k
(@dma_k)
Active Member
Filling the area in a strange way between circular perimiters

Dear all,

I have "Perimeters" setting set to 2. With this setting I observe the phenomena that on circular shells the head is jumping from one surface to another trying to fill in the gap. The is not efficient.

The issue can be workarounded by increasing the "Perimeters" setting (then the gap is filled with smooth circular lines) but I would suggest that slicer does this automatically.

PrusaSlicer v2.3.0.

 

Posted : 18/06/2021 9:31 am
Share: