eSun ePA-CF, Carbon Fibre Slicer Profile.
 
Notifications
Clear all

eSun ePA-CF, Carbon Fibre Slicer Profile.  

Page 8 / 8
  RSS
cwbullet
(@cwbullet)
RE: eSun ePA-CF, Carbon Fibre Slicer Profile.

Yup.  They droop on the windshield of a car.  

Posted by: @joantabb

I have had PLA Items  go soft in the sun...
or on a radiator

could higher temperature be the issue

PLa has a low glass transition temperature

regards Joan

 

--------------------
Chuck H
3D Printer Review Blog...
Posted : 25/11/2021 12:07 pm
DKGuffe
(@dkguffe)
Active Member
RE: eSun ePA-CF, Carbon Fibre Slicer Profile.

I was talking about the eSun Nylon HT CF, it's supposed to be 170MPA at 150 degrees, short term up to 180 degree C, and it's pliable and soft like licorice at 20 degree C after a couple of weeks.

Posted : 26/11/2021 1:54 am
JoanTabb
(@joantabb)
Moderator
RE: eSun ePA-CF, Carbon Fibre Slicer Profile.

Good luck!

I hope the supplier sorts this. 
regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK...
Posted : 28/11/2021 10:39 pm
Page 8 / 8
Share: