Ender 5 Pro with 0.25 Nozzle, how to configure?
 
Notifications
Clear all

Ender 5 Pro with 0.25 Nozzle, how to configure?  

  RSS
RichieW
(@richiew)
New Member
Ender 5 Pro with 0.25 Nozzle, how to configure?

Hi everyone

Currently I'm struggling to create a profile for my Ender 5 Pro when using a 0.25mm nozzle.

I love using the PrusaSlicer as it creates much cleaner prints than Cura. But now I want to print smaller parts with a 0.25 nozzle and I was not able to figure out on how to do it. In Cura it was not that hard, but until now I struggled in PrusaSlicer.

Does anyone have advice for me (or a link to an article or forum thread where this already has been discussed)?

Best wishes from Switzerland
Richard

Best Answer by Neophyl:

Try looking at Bob website (he is a member here - Bobstro)  https://projects.ttlexceeded.com/3dprinting_prusaslicer_profiles.html#customizing-printer-settings

Posted : 22/03/2021 3:27 pm
Neophyl
(@neophyl)
Famed Member
RE: Ender 5 Pro with 0.25 Nozzle, how to configure?

Try looking at Bob website (he is a member here - Bobstro)  https://projects.ttlexceeded.com/3dprinting_prusaslicer_profiles.html#customizing-printer-settings

Posted : 22/03/2021 3:54 pm
RichieW liked
bobstro
(@bobstro)
Illustrious Member
RE: Ender 5 Pro with 0.25 Nozzle, how to configure?

I've also got a bunch of notes on using different nozzles here

Thanks for @Neophyl!

My notes and disclaimers on 3D printing and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan...
Posted : 22/03/2021 5:33 pm
Neophyl
(@neophyl)
Famed Member
RE: Ender 5 Pro with 0.25 Nozzle, how to configure?

That’s the link I was looking for but it seems your websites growth is futzing me 😉

Posted : 22/03/2021 6:03 pm
bobstro
(@bobstro)
Illustrious Member
RE: Ender 5 Pro with 0.25 Nozzle, how to configure?
Posted by: @neophyl

That’s the link I was looking for but it seems your websites growth is futzing me 😉

Lots of interest in nozzles & PrusaSlicer. I'm doing topic pages with details, then "techniques" on how to combine them. A good page on "configuring prusaslicer for a new nozzle" is now on the list.

 

My notes and disclaimers on 3D printing and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan...
Posted : 22/03/2021 6:09 pm
Share: