Ender 5 Pro with 0.25 Nozzle, how to configure?
Hi everyone
Currently I'm struggling to create a profile for my Ender 5 Pro when using a 0.25mm nozzle.
I love using the PrusaSlicer as it creates much cleaner prints than Cura. But now I want to print smaller parts with a 0.25 nozzle and I was not able to figure out on how to do it. In Cura it was not that hard, but until now I struggled in PrusaSlicer.
Does anyone have advice for me (or a link to an article or forum thread where this already has been discussed)?
Best wishes from Switzerland
Richard
Best Answer by Neophyl:
Try looking at Bob website (he is a member here - Bobstro) https://projects.ttlexceeded.com/3dprinting_prusaslicer_profiles.html#customizing-printer-settings
RE: Ender 5 Pro with 0.25 Nozzle, how to configure?
Try looking at Bob website (he is a member here - Bobstro) https://projects.ttlexceeded.com/3dprinting_prusaslicer_profiles.html#customizing-printer-settings
RE: Ender 5 Pro with 0.25 Nozzle, how to configure?
I've also got a bunch of notes on using different nozzles here.
Thanks for @Neophyl!
RE: Ender 5 Pro with 0.25 Nozzle, how to configure?
That’s the link I was looking for but it seems your websites growth is futzing me 😉
RE: Ender 5 Pro with 0.25 Nozzle, how to configure?
That’s the link I was looking for but it seems your websites growth is futzing me 😉
Lots of interest in nozzles & PrusaSlicer. I'm doing topic pages with details, then "techniques" on how to combine them. A good page on "configuring prusaslicer for a new nozzle" is now on the list.