Notifications
Clear all

Brim not connecting to object  

  RSS
Sean
 Sean
(@sean)
New Member
Brim not connecting to object

I'm not able to get the brim to actually connect with the first layer of my print in Prusa Slic3r.  I've tried adjusting brim width by 0.01mm at a time to maybe try to compensate for first layer extrusion widths, but there's always a gap.  Am I missing something?  I couldn't find a setting for adjusting the gap, so I assume there shouldn't be any gap.

Brim not connected to object

This topic was modified 4 years ago 2 times by Sean
Posted : 12/06/2020 10:18 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Brim not connecting to object

try turning off elephants foot correction!

Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 12/06/2020 10:29 pm
Sean
 Sean
(@sean)
New Member
Topic starter answered:
RE: Brim not connecting to object

@joantabb

Beautiful!  Been using Cura to get this working, but now I can go back to Slic3r.

Thanks so much!

No more gap!

Posted : 12/06/2020 10:35 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Brim not connecting to object

🙂

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 12/06/2020 11:34 pm
Uko
 Uko
(@uko)
Member
RE: Brim not connecting to object

Hey, sorry for annoying you people, but your comments can be useful here: https://github.com/prusa3d/PrusaSlicer/issues/4736

Posted : 13/09/2020 10:43 pm
Share: