Notifications
Clear all

power panic not working?  

  RSS
manofmerr
(@manofmerr)
Active Member
power panic not working?

This is my first prusa product, but from what i understand, power panic should allow the printer to just resume a print after losing power. I was printing something small, so a short print, and the power flickered on and off a few times, and the printer stayed off. I assumed first that upon turning it on it would resume, and when that didn't happen, that going to the print file in question would trigger something, but I've seen nothing explicitly stating that it will resume the print.

I'm wondering if this feature works, and if so, how it looks when it does? Is it actually automatic, and does it indicate anything if it's not? I really don't want to try resuming my print if its just going to crash itself into the film, making what i imagine would be a very unpleasant mess. I was also wondering if this was caused by the power flickering, although i really just want to know if this feature works in general.

This topic was modified 4 years ago 2 times by manofmerr
Posted : 04/11/2019 7:39 pm
Michele
(@michele)
Active Member
RE: power panic not working?

I was also looking how this feature works...if it is working...

Few days had i short blackout but i did not see or i did not know how to resume the print....

Anyone has more information about this?

Thanks a lot.

Posted : 17/11/2019 9:14 am
Michele
(@michele)
Active Member
RE: power panic not working?

Perhaps @joantabb do you have an answer to our question?

Posted : 17/11/2019 8:01 pm
patrick.v2
(@patrick-v2)
Active Member
RE: power panic not working?

Have the same problem - power panic is not working

Posted : 18/11/2019 10:09 am
Share: