How to add layer height/resin combinations to Slicer
 

How to add layer height/resin combinations to Slicer  

  RSS
lewis53
(@lewis53)
Active Member

Hello,

Can anyone please tell me how to, for example, create a material setting in Slicer that will allow me to use a 0.035 mm layer height with Prusa Transparent Tough resin?  My Slicer allows only Prusa Orange Tough with 0.035 mm layer height.

Thanks,

Lewis.

Posted : 04/12/2019 12:28 pm
joan.t
(@joantabb)
Veteran Member Moderator

Hi Lewis, 

If you go to the Material settings tab in Prusa Slicer, the screen will open with the currently set profile, as in the picture below.

If you make your changes and save the profile with a new name, as shown in the left of the picture above, then your new profile should become available in the plater window, as shown in the right hand side of the window above

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK...
Posted : 04/12/2019 2:08 pm
lewis53
(@lewis53)
Active Member

Many thanks, Joan. It works.

Lewis.

Posted : 05/12/2019 10:55 am
joan.t
(@joantabb)
Veteran Member Moderator

Excellent news, Lewis,

 

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK...
Posted : 05/12/2019 5:24 pm
Share:

Please Login or Register