Notifications
Clear all

Resin Calibration results  

  RSS
FG's
 FG's
(@fgs)
Active Member
Resin Calibration results

All, 

Has your resin calibration come up this way? Should I expect better results or this is how it is for PRUSA Blue Flexible Resin? 

I am experiencing adhesion problems for the past couple of weeks, so it is difficult to troubleshoot

 

See attached image form my recent printResin Calibration Failedcalibration failed 

This topic was modified 3 years ago by FG's
Posted : 31/10/2020 4:11 pm
Michael
(@michael-4)
Trusted Member
RE: Resin Calibration results

I've found Monocure3D Platebond applied to the build plate helps the print stick to the build plate better than the FEP. Platebond works with any resin. See https://monocure3d.com.au/product-category/platebond/?v=322b26af01d5

Urethane based resins such as Monocure3D Tuff or Big Vat stick to the build plate so hard I don't use platebond. Instead I use my tack hammer and putty knife to hammer the print off the print bed.

Posted : 11/11/2020 6:59 am
Share: