Notifications
Clear all

Need print trouble shooting. - print layers seperating  

  RSS
Monsterequipped
(@monsterequipped)
New Member
Need print trouble shooting. - print layers seperating

I have printed 3 times now. The first came off of the metal plate and stuck to the clear film.  The second two printed.  Both have visible layer separations. The last print warped enough it would not fit within the first print (I left .25mm clearance).  Print layers seperating even more after alcohol wash.  anyone else having issues?

I'm a 6 volt guy in a 12 volt world

Posted : 25/06/2020 1:47 pm
Area51
(@area51)
Member
RE: Need print trouble shooting. - print layers seperating

I can be difficult to troubleshoot without the project file. Save, zip and upload the project 3mf file if possible.

Support and how the model is oriented is important and that is reflected in the project file. I'm not an expert - a lot of other users in the forum has more experience with SL1 than me and I would like to hear their advice.

Have a look at my models on Printables.com 😉

Posted : 25/06/2020 6:53 pm
Monsterequipped
(@monsterequipped)
New Member
Topic starter answered:
RE: Need print trouble shooting. - print layers seperating

Thank you for the response. Just tried to post zip file and it was too large. I am printing one of them again but with a more angled orientation and increased exposure time. If this doesn't solve the layer and distortion problem i will post pictures of the print.

I'm a 6 volt guy in a 12 volt world

Posted : 25/06/2020 8:18 pm
Share: