MMU2s on top of IKEA Lack  

  RSS
Valiran
(@valiran)
Eminent Member

Hello!

I'm a dick at modeling 3D pieces, but I know there are good people at this here... 🙂

Can someone design the red piece on my scheme?

The purpose is to have the MMU2s outside the lank enclosure, bent in the front, to facilitate maintenance on MMU2s?

Big thank !

...
Posted : 12/05/2020 11:24 am
pcweber
(@pcweber)
Estimable Member

I tried, never done this before.

https://www.thingiverse.com/thing:4393694

Phil

Stay safe and healthy, Phil...
Posted : 24/05/2020 10:31 pm
Valiran
(@valiran)
Eminent Member

Man, you deserve a big thank ! 🍺 

...
Posted : 25/05/2020 2:47 pm
pcweber
(@pcweber)
Estimable Member

Let me know if you use it. 

 

Phil

 

Stay safe and healthy, Phil...
Posted : 25/05/2020 2:51 pm
Valiran
(@valiran)
Eminent Member

Yes I'm going to use it 🤗 , after I finish the reprint of my MMU2s 😥 

...
Posted : 25/05/2020 2:59 pm
pcweber
(@pcweber)
Estimable Member

Good luck, 

Phil

Stay safe and healthy, Phil...
Posted : 25/05/2020 3:01 pm
tom.v6
(@tom-v6)
Active Member

I put the MMU on the top, sideways.    Did a large post about it here: https://forum.prusaprinters.org/forum/original-prusa-i3-mk3s-mk3-user-mods-octoprint-enclosures-nozzles-.../official-3d-printer-enclosure-from-prusa-research/paged/6/#post-138633    and there is a picture after it.     I still love the easy access and it was retro-fit from a Prusa LACK enclosure v1 to support the MMU2.   Still loving it.

Posted : 18/11/2020 1:02 am
Share:

Please Login or Register