Notifications
Clear all

Enclosure with MK3 & MMU2  

  RSS
RalfLueders
(@ralflueders)
New Member
Enclosure with MK3 & MMU2

IKEA Metod cabinet, my enclosure design with aluminium frame and acrylic glass walls and doors, Prusa i3MK3 with MMU2, octoPi print server on Raspberry Pi with 5MP IR camera, own design of ball-bearing spool holders and PTFE tube holders.

Enclosure keeps heat and noise inside, humidity out.
All filament is stored in 90um bags with Drypak 70g desiccant bags inside.

Great print results 😀

Posted : 11/01/2019 3:22 pm
Lize, and liked
Mindaugas Gelumbauskas
(@mindaugas-gelumbauskas)
New Member
RE: Enclosure with MK3 & MMU2

Very nice 🙂 can you share your design?

Posted : 23/12/2020 2:42 pm
You liked
MileHigh3Der
(@milehigh3der)
Honorable Member
RE: Enclosure with MK3 & MMU2

I have something very similar , but no where near as elegant.  Those aren’t auto rewinding- and my similar set up spools will end up getting tangled  because of then back feed during spool change.  The inherent coil/twist of petg filaments can cause problems.

Posted : 05/03/2021 6:04 am
Artur
(@artur)
New Member
RE: Enclosure with MK3 & MMU2
Do you have any problems when printing without buffer?
Posted : 13/03/2021 9:18 pm
Share: