Print with BVOH at interface taking way too long, unnecessarily switching filament on each layer
 
Notifications
Clear all

Print with BVOH at interface taking way too long, unnecessarily switching filament on each layer  

  RSS
ryan
 ryan
(@ryan-5)
New Member
Print with BVOH at interface taking way too long, unnecessarily switching filament on each layer

I am printing a variant of this with bvoh at interfaces:

https://www.thingiverse.com/thing:3234856

The problem is that it seems that the slicer uses bvoh on each layer, so the printing time is well over a day.

Is there any way to modify the support structure settings so that it doesn't have to switch back and forth so much?

Posted : 01/11/2020 11:44 pm
Share: