Notifications
Clear all

Layer Shift  

  RSS
Ypkwok
(@ypkwok)
New Member
Layer Shift

Hi, 

I tried printing twice with the same file, both times there is an x-axis layer shift at the layer height.  Just wondering if this is a Prusaslicer issue? 

Posted : 02/07/2020 9:51 pm
KevinK
(@kevink)
Trusted Member
RE: Layer Shift

Looks like you are getting multiple layer shifts.  First thing I would check is the tightness of the x-axis stepper set screws.  I had them loosen on my MK3S and nearly pulled my hair out before I realized it was a simple problem.  Unfortunately by the time I saw the "obvious" issue I had disassembled enough stuff to need to redo calibrations.

Posted : 03/07/2020 3:26 am
Share: