Dragonstone Print 🙂  

Dragonstone Print 🙂

My first real print using the presliced Dragonstone model on the weekly prints. I like these gcode samples as it gives me a good idea of what to aim for when I slice my own models. Overall it turned out great using eSun: 1: eSilk Cyan, 2: eMarble , 3: eSilk Lime.

Couple of notes:
1) The Model was too far to the right on my build plate and Carrage hit the end stop on the right, which resulted in a shifted print after the first line. It went on to print just fine without intervention but if it had happened later in the print there would have been a layer shift. Note: I did print using Octoprint, so not sure if this contributed.
2) There was some staining of the marble in the middle part of the 2 Towers from the Cyan. Seems the purge tower was plenty for the rest of the model just not for the smaller parts of the print.