Notifications
Clear all
Change the Extruder used for Infill?
I'm about to do a print that has many filament changes, and it just struck me that because of the way the exterior of the print is laid out, if I could change the extruder used for infill from Ext1 to Ext2 I could cut the number of filament changes down by 90%. I can't see a way to do this in PrusaSlicer.
Does anyone have a secret way to do this?
Posted : 26/01/2020 5:57 pm
Topic starter
answered:
RE: Change the Extruder used for Infill?
I should mention that changing settings In Multiple Extruders for all the infill , raft and support settings to #2, but it still want to use #1.
Posted : 26/01/2020 6:04 pm