Wipe Area on Top of MMU Print necessary?  

  RSS
thomas.b67
(@thomas-b67)
New Member

Tinkering around with MMU2 and saw this unecessary line on Top of the Wipe Tower with no connection to the Tower itself in PrusaSlicer 2.0.0.

Am i doing something wrong? Is this Line necessary for anything, or is this possibly a bug in PrusaSlicer? 

 

Thank you very much for your help.

Kind Regards, 

Tom

Best Answer by richard.l:

You're not doing anything wrong and there isn't a bug in Slicer. This is the purge before the final unload at the end of the print. It should fall harmlessly down.

Posted : 19/06/2019 10:31 am
richard.l
(@richard-l)
Member Moderator

You're not doing anything wrong and there isn't a bug in Slicer. This is the purge before the final unload at the end of the print. It should fall harmlessly down.

...
Posted : 19/06/2019 3:00 pm
thomas.b67
(@thomas-b67)
New Member

Ah... Ok, that makes sense... 

Thanks a lot for your help...

 

Kind Regards,

Tom

Posted : 19/06/2019 3:26 pm
Share:

Please Login or Register