Notifications
Clear all

Pinda probe issue after upgrading?  

  RSS
johndavismit
(@johndavismit)
New Member
Pinda probe issue after upgrading?

I am having issues calibrating my printer after upgrading to the mmu2s.

When I try to calibrate my xyz I set the extruder to the top, then click ok and it flinches, then tells me it failed.

 

When I go to "show endstops" the z position keeps switching between 0 and 1. I pulled the pinda off the extruder carriage and it still shows the same result. Before ordering a replacement is there anything else I can try?

Posted : 11/10/2021 9:50 pm
johndavismit
(@johndavismit)
New Member
Topic starter answered:
please help?

Does anyone here have any advice?

Posted : 12/10/2021 3:30 pm
Lynn
 Lynn
(@lynn)
Estimable Member
Try this

I often have problems with XYZ calibration failures if my extruder is positioned near and end stop when I start the process.  Position the extruder mid way between all the stops (~center of print volume in all three axis)  and try again. 

Posted : 12/10/2021 5:16 pm
Share: