Notifications
Clear all

[Solved] Idler motor driver no output  

  RSS
Loenja
(@loenja)
Active Member
Idler motor driver no output

Hi All I am getting 0v output from P10, where P8 &P9 give 12v to the motors when my MMU2S board is powered on.
I suspect a driver fault, but is there anything else I could troubleshoot before I get a new board?

Best Answer by Loenja:

A reflow appears to have made at least some difference in my case.

Posted : 26/11/2020 3:30 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: Idler motor driver no output

I think you are right, but I would support in the chat.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 26/11/2020 9:12 pm
Loenja
(@loenja)
Active Member
Topic starter answered:
RE: Idler motor driver no output

A reflow appears to have made at least some difference in my case.

Posted : 03/12/2020 2:51 pm
Share: