Official support for flexibles with MMU. How soon is soon?
 
Notifications
Clear all

Official support for flexibles with MMU. How soon is soon?  

  RSS
Yveske
(@yveske)
Estimable Member
Official support for flexibles with MMU. How soon is soon?

Flexible support for MMU2S is promised  'soon', will it be part of the upcoming prusaslicer update ?

Will MMU support Hemera ?

I'm not able to print flexibles now, not even in single colour mode and would like to do this again 'soon'.

Having problems with bed adhesion every morning......
Posted : 10/02/2020 6:36 pm
vintagepc
(@vintagepc)
RE: Official support for flexibles with MMU. How soon is soon?

Will MMU support Hemera ?

Unlikely. It doesn't officially support anything butt the stock setup. (Doesn't mean it's not possible to make it work though... but you'll need custom firmware)

Posted : 10/02/2020 7:25 pm
Nikolai
(@nikolai)
Noble Member
RE: Official support for flexibles with MMU. How soon is soon?
Posted by: @yveske

Will MMU support Hemera ?

The question should be if PR will support Hemera at all. The answer is most likely not.

Current MMU2 is not able to handle flexible filament. My guess is that after reworked version it might support semi flex filament. But I don't see NinjaFlex printing on MMU2. The whole design is in conflict with non-flex printing.

Often linked posts:
Going small with MMU2
Real Multi Material
My prints on Instagram...
Posted : 10/02/2020 8:24 pm
Share: