Notifications
Clear all

MMU for support material  

  RSS
Steve
(@steve-4)
Estimable Member
MMU for support material

Will the MMU work for printing PETG and support material?  What is the experienced failure rate for the filament change between model material and support material? How much material is wasted between those changes?

I asked Prusa support this question, and they won't answer me.

This is typically why you want dual extruders.

 

Senior Life member of IEEE.

Posted : 02/05/2019 1:40 pm
Mike_wth
(@mike_wth)
Active Member
RE: MMU for support material

It's a pain. I'm working on it.... Not right there, but step by step I get closer.

Read the entire story here.

Posted : 02/05/2019 11:13 pm
Share: