Notifications
Clear all

pinda not detect filament out.  

  RSS
jakub.j5
(@jakub-j5)
New Member
pinda not detect filament out.

Hi,
I have problem with MMU2 and MK3.
It prints fine multicolor few fines, but then ocures problem with detecting filament out of MMU2 during filament change (probably).
MMU tries to roll it out, but fillament is out allready. red led is flashing.
Cure is to pull fillament in few cm, then press center MMU button. It tries pull out again and after several tries it succeed and pull in other fillamnet and continue printing.
What should make problem?

Posted : 18/03/2019 11:30 am
Share: