Notifiche
Cancella tutti

Minimal rolling back from MK3S-MMU2S to MK3S  

Pagina 2 / 2
  RSS
JPG_master
(@jpg_master)
Eminent Member
RE: Minimal rolling back from MK3S-MMU2S to MK3S

@baklin

Hi, haha ...

It took me several times reading to identify you starting comment re the manual. Was distracted by the big appearance of the citation box.
Thank yoot for this, IT makes it crystall clear to me know. I did not recognizes this description in the printed version.

So I will follow this and thanks again for advising.

Postato : 04/05/2021 9:34 am
Legacy 3D Printing
(@legacy-3d-printing)
Active Member
RE: Minimal rolling back from MK3S-MMU2S to MK3S

I unhooked the MMU2s like Kevin described but 10 mins into my first print (of 2.25 hour print) it stopped printing and ejected the filament and asked me to load new filament. Is this because we are not replacing the sensor in the top of the extruder? I did re-slice the file to the plain MK3s profiles. Did I miss something? I can not sit here and babysit these prints all the time. I wish I had 8 hours to do that. Please advise.

Postato : 28/10/2023 7:44 pm
Pagina 2 / 2
Condividi: