Notifications
Clear all

How to manage MMU2S when it got stuck during printing  

  RSS
michele.b3
(@michele-b3)
Eminent Member
How to manage MMU2S when it got stuck during printing

It would be nice to be able to fix MMU2S when it got stuck during printing so that we can avoid trashing the whole work away.

I found sometimes that the led is selecting a filament but the selector is on a different one  or even the idler is posed on a different filament than the one (correct) with the led enlighted.

Since there are 3 buttons on MMU2S and , as far as I know only one is of use today, it would be nice if it could be possible to recalibrate via a single button during a print (I mean MMu2S got stuck, i remove what it got stuck then I woulld like to be able to call a calibration of the MMU2S itself before proceeding angain with the pending print.)

This would fix many halted prints.

Is there anyone the have a map of what the 3 buttons can be used for?

Thanks

Posted : 02/10/2019 5:16 pm
Lichtjaeger
(@lichtjaeger)
Noble Member
RE: How to manage MMU2S when it got stuck during printing

Read the manual (page 38).

The left button moves the filament a bit in the desired direction.

The middle button checks if the error is solved.

The right button continues the print after solving the error.

Posted : 02/10/2019 5:36 pm
Share: