Notifications
Clear all
Cant get first layer calibration, continuous extrusion.
I've been through the service menu calibration (at least 5-6 times) the most recent one was successful. So I went back through the wizard. evevrything tests fine EXCEPT when it goes to do the first layer calibration:
1. Moves to home, okay....
2. Selects Filament, okay...
3. Loads Filament, UGH WTF it just parks there and extrudes a giant blob of plastic and doesnt stop until I hit the power switch!
Posted : 14/04/2019 7:40 pm
Topic starter
answered:
Re: Cant get first layer calibration, continuous extrusion.
nvm, it looks like my Idler Door was too tight!
Posted : 14/04/2019 7:57 pm
Re: Cant get first layer calibration, continuous extrusion.
Check your IR sensor is triggering and has been adjusted correctly - I had the same issue mid filament change and on restart - after checking the IR sensor things are back to normal
Posted : 15/04/2019 6:20 pm