Notifications
Clear all

Moons stepper orientation and Fan support  

  RSS
PDJ33
(@pdj33)
New Member
Moons stepper orientation and Fan support

Just upgrading to a 3s+ and I had a moons drop in stepper available, after changing, I found that the fan support gets in the way of the moons cables/connector.

The question is, can I turn the stepper on its side?

Or is there a reason for the orientation of the stepper motors (other than cable length of course)

Posted : 15/09/2021 2:19 pm
cwbullet
(@cwbullet)
Illustrious Member
Stepper

Only the cable.

--------------------
Chuck H
3D Printer Review Blog...
Posted : 17/09/2021 4:39 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Moons stepper orientation and Fan support

If the stepper rotation direction is not correct, you may have to swap the two middle wires (green, red). Of course you can choose the position of the connector as you like. This depends on the length of the connector wires.

wbr,

Karl

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen....
Posted : 17/09/2021 5:42 pm
Share: