Bondtech emits clicking/squeaking sound when retracting filament during print
 
Notifications
Clear all

Bondtech emits clicking/squeaking sound when retracting filament during print  

  RSS
AmishTechSupt.
(@amishtechsupt)
New Member
Bondtech emits clicking/squeaking sound when retracting filament during print

Following a Bondtech upgrade on my MK3s, it has begun to emit a slight click (squeak when listened to closely) when the extruder retracts the filament during prints.  I've adjusted the 2-4 turns that Bondtech suggests on the idler screw, but the sound remains.  are there other parts that need attention (loosen / tighten)? 

 

Thanks in advance. 

Posted : 18/05/2020 1:55 am
Shrimply Pibbles
(@shrimply-pibbles)
Active Member
RE: Bondtech emits clicking/squeaking sound when retracting filament during print

I am currently having the same issue after upgrading to the bondtech, did you happen to resolve the issue by chance?

 

Posted : 07/01/2021 8:13 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: Bondtech emits clicking/squeaking sound when retracting filament during print

@shrimply-pibbles

After 2 years, I am having this issue also.  Odd.  Clicks and then stops printing.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 10/01/2021 4:57 am
evillvi77
(@evillvi77)
Active Member
RE: Bondtech emits clicking/squeaking sound when retracting filament during print

I am also having this issue. I believe the motor is bad.

Posted : 14/02/2021 4:15 am
cwbullet
(@cwbullet)
Illustrious Member
RE: Bondtech emits clicking/squeaking sound when retracting filament during print

I loosened by X idler/tension screw and mine stopped clicking. 

--------------------
Chuck H
3D Printer Review Blog...
Posted : 14/02/2021 1:14 pm
Share: