Adding of External MOSFET for both Heat Bead & Extruder  

  RSS
smistry.sales
(@smistry-sales)
New Member

Hi,

I have the MK3s. I would like to add External MOSFET for both the extruder header and the heat bed. I understand how to connect the heater ends to MOSFETs. But what I don't know the power end. The PSU has 2  24V outputs.  I know that either 1, or 2 or both are involved in the board & stepper motor, I don't care about these as I will supply them the same way already. But my question is about extruder and bed heaters.

1) Is it that 1 terminal supply to both extruder & bed's heaters? 
or 2) they are supplied separately?

Regards
Sanjay

Posted : 02/08/2020 12:18 pm
Share:

Please Login or Register