Notifications
Clear all

Y-Frame holes for upgrading MK2 to MK2S  

  RSS
david.b14
(@david-b14)
Honorable Member
Y-Frame holes for upgrading MK2 to MK2S

Did anyone doing the upgrade use the hand drill part that came w/ the upgrade kit?

I am thinking about using a drill press and I am looking for an all 3D printable drill press like the one below, any other suggestions?

https://www.myminifactory.com/object/pillar-drill-562

...
Posted : 27/05/2017 3:20 pm
PJR
 PJR
(@pjr)
Moderator
Re: Y-Frame holes for upgrading MK2 to MK2S

Yes, I used the supplied tool. A lot simpler than trying to make it complicated...

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 27/05/2017 6:06 pm
david.b14
(@david-b14)
Honorable Member
Topic starter answered:
Re: Y-Frame holes for upgrading MK2 to MK2S

Good point. I was concerned that the drill bit may break off or get stuck.

I will give it a try with the included tool after I print the new parts.

...
Posted : 31/05/2017 3:49 pm
PJR
 PJR
(@pjr)
Moderator
Re: Y-Frame holes for upgrading MK2 to MK2S

David

It's not hard/tight; just a matter of removing some paint and a very small sliver of aluminium.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 31/05/2017 5:34 pm
Share: