Weird precise layer deflection, can't find the reason.
 
Notifications
Clear all

Weird precise layer deflection, can't find the reason.  

  RSS
ahmet emin.k
(@ahmet-emin-k)
Active Member
Weird precise layer deflection, can't find the reason.

Bought 3d printer 2 weeks ago. First prints were smooth and good. Did not have any problem. Then these last two days it start doing this :

photo upload

In every part it is on another area, but for same parts it is precisely at the same area. It is not big of a deal, part dimentions are good but still it is annoying. Searched for common problems but found nothing alike. Is there a known cause that I did not see and a solution?

Posted : 06/10/2017 12:15 pm
PJR
 PJR
(@pjr)
Moderator
Re: Weird precise layer deflection, can't find the reason.

It's called a seam. It's where the perimeter starts and stops.

There are a few "seam hiding" parameters in the slicer.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 06/10/2017 1:16 pm
ahmet emin.k
(@ahmet-emin-k)
Active Member
Topic starter answered:
Re: Weird precise layer deflection, can't find the reason.


It's called a seam. It's where the perimeter starts and stops.

There are a few "seam hiding" parameters in the slicer.

Peter

I see, thanks for help.

Posted : 06/10/2017 1:21 pm
Share: