Notifications
Clear all

[Closed] Odd Wave pattern on diagonals  

  RSS
nickexile
(@nickexile)
New Member
Odd Wave pattern on diagonals

Hey there fell Prusa-ites,
Has any one run across this strange behavior before? I am getting ripples or waves on my diagonal lines.

I am using the MK2 btw.
I thought it might be the extrusion causing this, but temp changes and other settings have no effect, and it appears to follow a pattern.
Any ideas are welcome!
Thanks Chappies.

...
Posted : 11/10/2016 3:17 pm
PJR
 PJR
(@pjr)
Moderator
Re: Odd Wave pattern on diagonals

Over-extrusion, possibly caused by nozzle being too low.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 11/10/2016 3:21 pm
admi-11
(@admi-11)
New Member
RE: Odd Wave pattern on diagonals
Posted by: @nickexile

Hey there fell Prusa-ites,
Has any one run across this strange behavior before? I am getting ripples or waves on my diagonal lines.

 

I am using the MK2 btw.
I thought it might be the extrusion causing this, but temp changes and other settings have no effect, and it appears to follow a pattern.
Any ideas are welcome!
Thanks Chappies.

Hey, have you figured out the issue? I'm having almost identical issue on a fresh built MK3S

Posted : 13/05/2020 12:03 am
Share: