Notifications
Clear all

[Closed] LCD won't turn on  

  RSS
Screwyluie
(@screwyluie)
Active Member
LCD won't turn on

just assembled. rambo board has power since I can see a green led but the lcd isn't on. checked the fuses and they're fine. unplugged everything but the power and lcd on the board, no change. tried reversing the ribbon cables on the board and that got the lcd to flash... actually it flashes every time I turn the knob next to it but that's all it does.

I'm at a loss.

...
Posted : 24/06/2017 8:24 pm
PJR
 PJR
(@pjr)
Moderator
Re: LCD won't turn on

You probably have the connectors wrong way round at RAMBo end. Red stripe is pin 10 in the Prusa world...

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…...
Posted : 24/06/2017 8:44 pm
Kaippe liked
Screwyluie
(@screwyluie)
Active Member
Topic starter answered:
Re: LCD won't turn on

that was correct. So I was following the online guide and is has this image: https://d17kynu4zpq5hy.cloudfront.net/igi/prusa3d/jX2D1nYD1pLOLoDt.large and in that image the connectors are 180degs backwards. Once I spun them around all is well and I'm off and printing. Thanks

...
Posted : 24/06/2017 11:47 pm
Kaippe
(@kaippe)
New Member
RE: LCD won't turn on

@pjr

Thanks, by checking I realize I has the cables in the wrong spot. And now it running through the sef-check. 

Posted : 05/07/2020 2:28 am
Share: