Calibration failed..consult the manual. Tried everything.
I have spent the better part of the day trying to get my i3 MK2S to calibrate again after moving it to a new enclosure. It calibrated just fine when I first built it and I followed the guidance of recalibrating after moving it but it just refuses. I have checked the carriage, used calibers on everything, verified that the heatbed lines are lined up with the Z axis and every other tip I could find. I am on the latest firmware and it seems to be consistenly failing after the 3 iteration point 4 if that helps at all. Please help
Re: Calibration failed..consult the manual. Tried everything.
Lucas, lower your Probe down to 0.75mm use a feeler gauge, once calibrated, set it back up at 1.5mm and try. Should fix that issue.
Prusa i3 MK2s MK2.5s Mk3 Mk3s BearPrusa Zaribo 320 - Kit Build - Rc Driver - Tweak freak...
âI know nothing about surpassing others. I only know how to outdo myself.â -Bushido-
Re: Calibration failed..consult the manual. Tried everything.
I was having the same issue. Look at my thread for how I went about fixing it
Re: Calibration failed..consult the manual. Tried everything.
I don't know if this was solved, but I had to reset my XYZ calibration after moving the printer before I could do a new calibration. Before reset it failed.