Power Recovery after December firmware update
 
Notifications
Clear all

Power Recovery after December firmware update  

  RSS
stefan.s17
(@stefan-s17)
New Member
Power Recovery after December firmware update

Hello, everyone and happy new year! I am super pleased with the new MK3 that I assembled it before Christmas. Super tool, guys, nice machine and support!
However, this morning I discovered that after a short power failure, the printer got the nozzle back to the place where it was supposed to resume the print job, but it wasn't moving, and the display was showing SD 0% progress (and it was so close to finish the 9 hour printing!).
I tried a power cut from the extension cord switch and got the same result: it resumed bed heating, moved to the right spot, but SD 0% progress and no moving.
Previously the firmware update, we had a power cut and the printer recovered ok (I noticed some filament spilled, but it was acceptable).

The question is: Do you think it's from the December firmware or can it be the new SD card that I am printing successfully for a week already? Or both? :geek:

Posted : 12/01/2018 1:23 pm
toby.k
(@toby-k)
Trusted Member
Re: Power Recovery after December firmware update

Were you printing in "Spiral Vase" mode?

Posted : 12/01/2018 2:29 pm
stefan.s17
(@stefan-s17)
New Member
Topic starter answered:
Re: Power Recovery after December firmware update

No spirals, Just rectangular pieces. It was finishing the last part (part + support material next to it).

Posted : 12/01/2018 4:34 pm
Share: