Notifications
Clear all

Weird lines after a certain part on the print  

  RSS
Matty
(@matty)
Active Member
Weird lines after a certain part on the print

Hi all! I have been trying to dial in my PETG settings, but i can't seem to remove the lines shown in the pictures that appear when the circles are drawn on the print, there is no lines before the circles as seen in the image. I am not too sure what could cause this, I have tried firmware updates and also calibrated the Linear advance + extrusion but has not resolved this sadly. I hope someone can help here thanks 🙂

Nozzle Temp: 240

Bed Temp : 85

Extrusion Multiplier: 1

Layer Height: 0.25

Retraction: 0.8

Retraction Speed: 35mm/s

Lift Z: 0

 

Posted : 20/04/2020 7:07 pm
Share: